Finden Sie schnell geräteprüfung für Ihr Unternehmen: 31 Ergebnisse

Hochgenaue optische berührungslose Messung von Durchmesser, Rundheit und Ziehwinkel von Drahtziehsteinen mit Ausbausatz zur Messung von Durchmesser und Rundheit von Drähten und Stäben The DGMS is a measuring system for Drawing Dies, Enameling Dies, Shaped Dies, Wires, Shaped Wires and Rods. The DGMS is designed modular. It consists of a basic system, which can be upgraded by several additional hard- and software modules. The measurement is performed optically by use of image processing. Each DGMS-system is equipped with two objectives. Depending on the diameter range to be covered, the typical combinations are 0,4x and 4x or 1x and 10x. The basic system is a fully equipped measuring instrument, ready for use. It provides the following standard measuring functions: -Diameter and Roundness of Drawing Dies and Enameling Dies -bore area of drawing dies and Enameling Dies With optional additional hard- and software modules, the following measuring functions can be added: -Reduction Angle of Drawing Dies -Diameter and Roundness of Wires -Parameters of Shaped Dies, Shaped Wires and Rods. REDUCTION ANGLE MEASUREMENT The DGMS can be equipped with hard- and software for the measurement of the reduction angle of wire drawing dies. This is an optional additional function, which can be also implemented with an upgrade. MEASUREMENT OF SHAPED DIES Shaped Dies can be measured with additional software modules. There are measuring functions for standard shapes available. For special shapes the software can be adapted to the special shape and the parameters to be evaluated. MEASUREMENT OF WIRES, SHAPED WIRES AND RODS For the measurement of wires, an additional mechanics for the mounting of the wire is necessary. This mechanics for fixing the wire can be mounted in the universal holder, which is also used for mounting the drawing dies. The universal holder belongs to the standard scope of supply of the DGMS. Beside the additional wire holder there is also a software upgrade necessary. The software upgrade provides an additional measuring module, with the capability to measure the wire diameter instead of the drawing die diameter.